The primary function of drilling fluid is to ensure that the rock cuttings generated by the drilllbit are continuously removed from the wellbore. If these cuttings are not removed from the bit face the drilling efficiency will decrease. It these cuttings are not transported up the annulus between the drillstring and wellbore efficiently the drillstring will become stuck in the wellbore. The mud must be designed such that it can:
1. Carry the cuttings to surface while circulating
2. Suspend the cuttings while not circulating
3. Drop the cuttings out of suspension at surface.

The rheological properties of the mud must be carefully engineered to fulfil these requirements. The carrying capacity of the mud depends on the annular velocity, density and viscosity of the mud. The ability to suspend the cuttings depends on the gelling (thixotropic) properties of the mud. This gel forms when circulation is stopped and the mud is static. The drilled solids are removed from the mud at surface by mechanical devices such as shale shakers, desanders and desilters. It is not economically feasible to remove all the drilled solids before re-circulating the mud. However, if the drilled solids are not removed the mud may require a lot of chemical treatment and dilution to control the rheological properties of the mud.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Post Navigation